RB-4000*

Screen Shot 2015-04-16 at 2.25.17 PM

Product Description

An excellent general purpose white water-borne Ethylene Vinyl Acetate. Used as glue lap, flexo adhesive and bag side seam. Will work well on most coatings. Viscosity can be adjusted to meet application requirements. Can be formulated to run on non-contact extrusion, Valco extrusion and wheel applicators.

Typical Physical Properties

Viscosity…………………….……. 400-3600 cps
pH…………………………………… 4.0-5.5
Solids………………………………. 55% +/- 3%
Spindle ………………………………… #4@20rpm

Handling & Storage

Diluent:                          Water, if required. Use as received.
Clean up:                       Warm water.
Storage container:    Store in a cool, dry area. Product should not be stored in direct sunlight. Product should not be used after freezing. For best results, we recommend the purchase of fresh adhesive every 3 months.

Components contained in this product conform to USDA and FDA regulations for use in food packaging, as stated in the Federal Food and Drug and Cosmetic Act, Title 21 under section 175 – 105. This guarantee is also intended to comply with USDA’s “Policy Governing Inspection of Packaging Materials”..

Note: The data presented is based upon tests believed to be reliable; however, RapidBond, Inc.™ does not guarantee their accuracy or completeness. RapidBond, Inc. assumes no responsibility for results obtained or for incidental or consequential damages arising from the use of this data.

RapidBond, Inc, LLC Guarantee

If any product is defective in workmanship or materials, RapidBond, Inc., LLC will replace the product, or refund the full purchase price. This warranty is in place of all other warrants, expressed or implied, and all implied warrants of a product for an intended use shall be solely up to the user. RapidBond, Inc., assumes no liability for consequential damages. Its liability shall in no event exceed the purchase price of materials_supplied by it.

To Print Press Here